Titan IIIC

Source: Wikipedia, the free encyclopedia.
Titan IIIC
Launch of a Titan IIIC
FunctionMedium-lift launch vehicle
ManufacturerMartin
Country of originUnited States
Size
Height137 ft (42 m)
Diameter10 ft (3.0 m)
Mass1,380,510 lb (626,190 kg)
Stages2-3
Capacity
Payload to LEO
Mass28,900 lb (13,100 kg)
Payload to GTO
Mass6,600 lb (3,000 kg)
Payload to Mars
Mass2,650 lb (1,200 kg)
Associated rockets
FamilyTitan
Launch history
StatusRetired
Launch sitesLC-40 & 41, CCAFS
SLC-6, Vandenberg AFB
Total launches36
Success(es)31
Failure(s)5
First flight18 June 1965
Last flight6 March 1982
Boosters (Stage 0) – UA1205
No. boosters2
Maximum thrust1,315,000 lbf (5,850 kN)
Specific impulse263 secs
Burn time115 seconds
PropellantSolid
First stage
Powered by2 LR87-AJ9
Maximum thrust1,941.7 kN (436,500 lbf)
Burn time147 seconds
PropellantN2O4 / Aerozine 50
Second stage
Powered by1 LR91-AJ9
Maximum thrust453.1 kN (101,900 lbf)
Burn time205 seconds
PropellantN2O4 / Aerozine 50
Upper stage – Transtage
Powered by2 AJ-10-138
Maximum thrust16,000 lbf (71 kN)
Burn time440 seconds
PropellantN2O4 / Aerozine 50
[edit on Wikidata]

The Titan IIIC was an expendable launch system used by the United States Air Force from 1965 until 1982. It was the first Titan booster to feature large solid rocket motors and was planned to be used as a launcher for the Dyna-Soar, though the spaceplane was cancelled before it could fly. The majority of the launcher's payloads were DoD satellites, for military communications and early warning, though one flight (ATS-6) was performed by NASA. The Titan IIIC was launched exclusively from Cape Canaveral while its sibling, the Titan IIID, was launched only from Vandenberg AFB.

History

The Titan rocket family was established in October 1955 when the Air Force awarded the Glenn L. Martin Company (later Martin Marietta and now Lockheed Martin) a contract to build an intercontinental ballistic missile (SM-68). It became known as the Titan I, the nation's first two-stage ICBM, and replaced the Atlas ICBM as the second underground, vertically stored, silo-based ICBM. Both stages of the Titan I used kerosene (RP-1) and liquid oxygen (LOX) as propellants. A subsequent version of the Titan family, the Titan II, was similar to the Titan I, but was much more powerful. Designated as LGM-25C, the Titan II was the largest USAF missile at the time and burned Aerozine 50 and nitrogen tetroxide (NTO) rather than RP-1 and LOX.

The Titan III family consisted of an enhanced Titan II core with or without solid rocket strap-on boosters and an assortment of upper stages. All Solid Rocket Motor (SRM)-equipped Titans (IIIC, IIID, IIIE, 34D, and IV) launched with only the SRMs firing at liftoff, the core stage not activating until T+105 seconds, shortly before SRM jettison. The Titan IIIA (an early test variant flown in 1964–65) and IIIB (flown from 1966 to 1987 with an Agena D upper stage in both standard and extended tank variants) had no SRMs.[1] The Titan III launchers provided assured capability and flexibility for launch of large-class payloads.

All Titan II/III/IV vehicles contained a special range safety system known as the Inadvertent Separation Destruction System (ISDS) that would activate and destroy the first stage if there was a premature second stage separation. Titans that carried Solid Rocket Boosters (SRBs) (Titan IIIC, IIID, 34D, and IV) had a second ISDS that consisted of several lanyards attached to the SRBs that would trigger and automatically destroy them if they prematurely separated from the core, said "destruction" consisting mainly of splitting the casings open to release the pressure inside and terminate thrust. The ISDS would end up being used a few times over the Titan's career.

Another slight modification to SRB-equipped Titans was the first stage engines being covered instead of the open truss structure on the Titan II/IIIA/IIIB. This was to protect the engines from the heat of the SRB exhaust.

Titan III/IV SRBs were fixed nozzle and for roll control, a small tank of nitrogen tetroxide was mounted to each motor. The N
2O
4 would be injected into the SRB exhaust to deflect it in the desired direction.

As the IIIC consisted of mostly proven hardware, launch problems were generally only caused by the upper stages and/or payload. The second launch in October 1965 failed when the Transtage suffered an oxidizer leak and was unable to put its payload (several small satellites) into the correct orbit. The third launch in December experienced a similar failure.

The fourth IIIC launch was used to send the LES 4 (Lincoln Experimental Satellite 4) into orbit. It was a US Air Force experimental communications satellite launched along with OV2-3, LES 3, and Oscar 4 from Cape Canaveral aboard a single Titan 3C rocket. It transmitted in X-band.

The fifth Titan IIIC (August 26, 1966) failed shortly after launch when pieces of the payload fairing started breaking off. Around 80 seconds, the remainder of the shroud disintegrated, causing loss of launch vehicle control as well as the payload (a group of IDCSP satellites intended to provide radio communication for the US Army in Vietnam). The ISDS activated automatically when one of the SRBs broke away from the stack and destroyed the entire launch vehicle. The exact reason for the shroud failure was not determined, but the fiberglass payload shrouds used on the Titan III up to this point were replaced with a metal shroud afterwards.

A Titan IIIC in November 1970 failed to place its missile early warning satellite in the correct orbit due to a Transtage failure and a 1975 launch of two DSCS II military communication satellites left in LEO by another Transtage failure.

On March 25, 1978, a launch of two DSCS II satellites ended up in the Atlantic Ocean when the Titan second stage hydraulic pump failed, resulting in engine shutdown approximately 470 seconds after launch. The Range Safety destruct command was sent, but it was unclear if the stage received it or if it had already broken up by that point.

The first Titan IIIC flew on June 18, 1965, and was the most powerful launcher used by the Air Force until it was replaced by the Titan 34D in 1982. The last IIIC was launched in March 1982.

Design

MOL mockup launch by a Titan IIIC on Nov. 3, 1966 from LC-41 Cape Canaveral

The Titan IIIC weighed about 1,380,000 lb (626,000 kg) at liftoff and consisted of a two-stage Titan core and upper stage called the Titan Transtage, both burning hypergolic liquid fuel, and two large UA1205 solid rocket motors.

The solid motors were ignited on the ground and were designated "stage 0". Each motor composed of five segments and was 10 ft (3.0 m) in diameter, 85 ft (26 m) long, and weighed nearly 500,000 lb (230,000 kg). They produced a combined 2,380,000 lbf (10,600 kN) thrust at sea level and burned for approximately 115 seconds.[2] Solid motor jettison occurred at approximately 116 seconds.[3]

The first core stage ignited about 5 seconds before SRM jettison. Designated the Titan 3A-1, this stage was powered by a twin nozzle Aerojet LR-87-AJ9 engine [4] that burned about 240,000 lb (110,000 kg) of Aerozine 50 and nitrogen tetroxide (NTO) and produced 1,941.7 kN (436,500 lbf) thrust over 147 seconds. The Aerozine 50 and NTO were stored in structurally independent tanks to minimize the hazard of the two mixing if a leak should have developed in either tank.

The second core stage, the Titan 3A-2, contained about 55,000 lb (25,000 kg) of propellant and was powered by a single Aerojet LR-91-AJ9, which produced 453.7 kN (102,000 lbf) for 145 seconds.[4]

The upper stage, the Titan Transtage, also burned Aerozine 50 and NTO. Its two Aerojet AJ-10-138 engines were restartable, allowing flexible orbital operations including orbital trimming, geostationary transfer and insertion, and delivery of multiple payloads to different orbits. This required complex guidance and instrumentation.[3] Transtage contained about 22,000 lb (10,000 kg) of propellant and its engines delivered 16,000 lbf (71 kN).

General characteristics

  • Primary Function: Space booster
  • Builder: Martin Marietta
  • Power Plant:
  • Length: 42 m
    • Stage 0: 25.91 m
    • Stage 1: 22.28 m
    • Stage 2: 7.9 m
    • Stage 3: 4.57 m
  • Diameter:
    • Stage 0: 3.05 m
    • Stage 1: 3.05 m
    • Stage 2: 3.05 m
    • Stage 3: 3.05 m
  • Mass:
    • Stage 0: Empty 33,798 kg/ea; Full 226,233 kg/ea
    • Stage 1: Empty 5,443 kg; Full 116,573 kg
    • Stage 2: Empty 2,653 kg; Full 29,188 kg
    • Stage 3: Empty 1,950 kg; Full 12,247 kg
  • Lift capability:
    • Up to 28,900 lb (13,100 kg) into a low Earth orbit with 28 degrees inclination.
    • Up to 6,600 lb (3,000 kg) into a geosynchronous transfer orbit when launched from Cape Canaveral Air Force Station, FL.
  • Maximum takeoff weight: 626,190 kg
  • Cost:
  • Date deployed: June 1965.
  • Launch sites: Cape Canaveral Air Force Station, FL., and Vandenberg Air Force Base, CA.

Launch history

Main article: List of Titan launches

References

  1. ^ "Titan 3B". Archived from the original on 2012-10-25. Retrieved 2013-02-15.
  2. ^ "Titan 3C". Astronautix. Archived from the original on December 25, 2014. Retrieved February 2, 2015.
  3. ^ a b "Titan". braeunig.us. Retrieved February 2, 2015.
  4. ^ a b Norbert, Bruge. "Titan III/IV Propulsion". B14643.de. Norbert Bruge. Retrieved 20 June 2017.
Wikimedia Commons has media related to Titan IIIC.
Retrieved from "https://en.wikipedia.org/w/index.php?title=Titan_IIIC&oldid=1233206359"