Search results

Results 1 – 15 of 15
Advanced search

Search in namespaces:

There is a page named "Stub-girder steel frame floor system" on Wikipedia

  • Thumbnail for Stub-girder system
    A stub-girder system (or stub girder system) is a model of steel frame structures consisting of beams and decking, originally developed in the early 1970s...
    2 KB (128 words) - 00:53, 2 April 2023
  • Thumbnail for Nexen Building, Calgary
    Nexen Building, Calgary (category All stub articles)
    completed in 1982. The Nexen Building employs a composite stub-girder steel-frame floor system, originally developed in part by Joseph Colaco. It is unique...
    6 KB (403 words) - 18:39, 20 May 2023
  • Thumbnail for Allen Center
    and has 34 floors. It is the 31st tallest building in the city. One Allen Center employs a composite stub-girder steel frame floor system, originally...
    14 KB (1,253 words) - 21:59, 4 August 2024
  • Thumbnail for Seismic retrofit
    jacketing – either through external steel components or by a complete jacket of reinforced concrete, often using stub connections that are glued (using...
    64 KB (8,327 words) - 03:14, 23 June 2024
  • Thumbnail for Longworth Hall
    Longworth Hall (category All stub articles)
    between the first floor doors are of Bedford limestone. 4.25 million bricks were used in the walls. Floor loads are carried on steel girders and these in turn...
    4 KB (354 words) - 18:10, 10 February 2023
  • Thumbnail for Bond Minicar
    vehicle required much additional strengthening to the floor, with a central steel backbone girder, a cross member between the rear wheels and further triangular...
    62 KB (7,667 words) - 20:55, 24 May 2024
  • Thumbnail for Newtown Tram Depot
    principals spanning between lattice girders bracketed off stub posts, over the tops of the main columns. The floors are largely of reinforced concrete...
    17 KB (2,112 words) - 14:01, 20 April 2024
  • Thumbnail for Hudson Terminal
    concrete was used to encase the structural steel frame. The I-beams were supported by columns or on plate girders. Large wind braces were not used; instead...
    69 KB (7,699 words) - 00:33, 20 May 2024
  • Thumbnail for George Washington Masonic National Memorial
    60 short tons (54 t) of steel reinforcing bars were used in this part of the wall. The GWMNMA believed that the second floor would be finished by the...
    139 KB (18,267 words) - 23:59, 17 July 2024
  • Thumbnail for T-54/T-55 operators and variants
    the loading mechanism required increasing the aft section of the turret. A stub case ejection port on rear of turret. The tank's armour protection was also...
    193 KB (22,718 words) - 10:23, 19 August 2024
  • Thumbnail for Isaac Young House
    bark on it, support the ceiling, while others have been replaced with steel girders. On the walls the stone and brick of the foundation is exposed. A cistern...
    23 KB (3,274 words) - 23:12, 13 May 2024
  • Thumbnail for List of F5, EF5, and IF5 tornadoes
    Roger (ed.). "The 1925 Tri-State Tornado Damage Path and Associated Storm System" (PDF). e-Journal of Severe Storms Meteorology. 8 (2): 1–33. doi:10.55599/ejssm...
    253 KB (10,483 words) - 18:01, 24 August 2024
  • replaced and other repairs were made, including the installation of a temporary stub bow. On 7 March 1943, she left Sydney for Puget Sound, sailing backward the...
    324 KB (55,432 words) - 07:39, 20 July 2024
  • pot of molten steel at a Foundry, and ends up getting turned into a variety of everyday items: steel girders, a refrigerator, a steel pole, nails, food...
    141 KB (1,224 words) - 22:52, 30 July 2024
  • Archer Avenue lines (category Independent Subway System)
    and run to Springfield Boulevard or Rosedale. Where the upper level tracks stub end, there is a provision for a portal to go outside if the line going to...
    71 KB (8,298 words) - 06:52, 10 June 2024