Springfield model 1873
This article needs additional citations for verification. (September 2021) |
Springfield Model 1873 | |
---|---|
![]() | |
Type | Breech-loading rifle |
Place of origin | ![]() |
Service history | |
In service | 1873–1903 |
Used by | ![]() ![]() |
Wars | American Indian Wars Spanish–American War Philippine–American War |
Production history | |
Designer | Erskine S. Allin |
Designed | 1872–1873 |
Manufacturer | Springfield Armory |
Produced | 1873–1884 |
No. built | 567,882 [1] |
Variants | Cavalry carbine with 22 in (560 mm) barrel Cadet rifle with 28 in (710 mm) barrel Infantry rifle with 30 in (760 mm) barrel |
Specifications | |
Length | 52 in (1,300 mm) |
Barrel length | 32.5 in (830 mm) |
Cartridge | 1873 Loading .45-70-405 (19,000 psi), 1884 loading 45-70-500 (25,000 psi)) |
Caliber | .45 in (11.43 mm) |
Action | Trapdoor |
Rate of fire | 12-13 rounds per minute, up to 25 rounds per minute have been recorded in ordnance department tests[2] |
Muzzle velocity | 1,350 feet per second (410 m/s) |
Maximum firing range | 2,500 yards (2,300 m)[2] |
Feed system | Breech-loading |
Sights | Open sights |
The Springfield Model 1873 was the first standard-issue breech-loading rifle adopted by the United States Army (although the Springfield Model 1866 had seen limited issue to troops along the Bozeman Trail in 1867). The rifle, in both full-length and carbine versions, was widely used in subsequent battles against Native Americans.
The Model 1873 was the fifth variation of the Allin trapdoor design, and was named for its hinged breechblock, which opened like a trapdoor. The infantry rifle model featured a 325⁄8-inch (829 mm) barrel, while the cavalry carbine used a 22-inch (560 mm) barrel. It was superseded by an improved model, the Springfield Model 1884, also in .45-70 caliber.
Selection process
From 1872 to 1873, a military board headed by Brigadier-General Alfred H. Terry conducted an examination and trial of 99 rifles from several domestic and foreign manufacturers, including those from Springfield, Sharps, Peabody, Whitney, Spencer, Remington, and Winchester, pursuant to the selection of a breech-loading system for rifles and carbines for the U.S. Military. The trials included tests for accuracy, dependability, rate-of-fire, and ability to withstand adverse conditions. Both single-shot and magazine fed systems were considered but, at the time, the single-shot was deemed to be more reliable and cheaper to mass-produce. Firing tests were held at the Springfield Armory and Governor's Island, where the average rate of fire for the Springfield was 8 rounds per minute for new recruits and 15 rounds per minute for experienced soldiers. The board recommended "No. 99 Springfield" which became the Model 1873.[3]
Ballistics as recorded in the 1874 and 1887 US Ordnance Department Reports
The rifle cartridge was designated as ".45-70-405", indicating a .45 caliber (11.63 mm) bore diameter, with 70 grains (4.5 g) of black powder, propelling a 405-grain (26.2 g) bullet. It had a muzzle velocity of 1,350 feet per second (410 m/s). A reduced-power load of 55 grains (3.6 g) of powder (Carbine Load) was manufactured for use in the carbine to lighten recoil for mounted cavalry soldiers.
The Springfield Model 1884 had a muzzle velocity of 1315.7 feet per second with a 500 grain lead bullet. The muzzle velocity of the carbine bullet was 1,150 feet per second. The 1884 model rifle generated 1525 ft lbs of energy at 100 yds, and 562.3 ft lbs of energy at 1,000 yards, with a maximum range of 3,500 yards.
![](http://upload.wikimedia.org/wikipedia/commons/thumb/f/fb/Velocity_1884_Springfield.png/220px-Velocity_1884_Springfield.png)
![](http://upload.wikimedia.org/wikipedia/commons/thumb/f/fc/Force_of_impact_1873_Springfield.png/220px-Force_of_impact_1873_Springfield.png)
Operating chamber pressure of the Springfield model 1873, firing the 45-70-400, is 19,000 psi [4] The operating chamber pressure of the Springfield Model 1884, firing the 45-70-500, is 25,000 psi.[2]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/d/d1/Trapdoor_springfield_pressure.png/220px-Trapdoor_springfield_pressure.png)
The average accuracy of the Springfield Model 1873 was a circle with an average radius of 1.7 inches at 100 yards, corresponding to an ~3.4 MOA. The average accuracy of the Springfield Model 1884 was a circle with an average radius of 1.3 inches at 100 yards, corresponding to ~2.6 MOA.[5] Therefore, the accuracy potential of the average Springfield Model 1884 is comparable to that of the German K98k or Springfield's later M1 Garand.
![](http://upload.wikimedia.org/wikipedia/commons/thumb/5/5c/Accuracy_1884_Springfield.png/220px-Accuracy_1884_Springfield.png)
U.S. ordnance department tests report that "A practiced person can fire this arm from 12 to 13 times per minute, loading from the cartridge-box. (It has been fired from the shoulder at the rate of 25 times per minute from the cartridge-box)."[2]
Use in combat
The rifle was originally issued with a copper cartridge case and used in the American West during the second half of the 19th century. However, poor quality control with copper cases and poor storage conditions not uncommonly led to cartridge case separations upon firing.
Original U.S. Ordnance Department instructions for the Springfield Model 1873 write: "Should the head of a cartridge come off in the act of firing, the best mode of extracting the shell is to take out a ball from a cartridge and reduce it with a knife or by rolling, so that it can be inserted into the muzzle of the barrel. Ram the ball hard with the ramrod when the breech-block is closed; this will upset the ball and fill the headless shell. Open the breech-block and the ball and shell can be easily pushed out with the ramrod."[6] Soldiers were later issued with a purpose-designed headless-shell extractor to remedy case-head separations and jams.
After the defeat of Lieutenant-Colonel George Armstrong Custer's battalion (armed with the carbine and carbine load ammunition) at the Battle of the Little Bighorn in June 1876, investigations first suggested that jamming of their carbines may have played a factor, although archaeological excavations in 1983 discovered evidence that only 3.4 percent of the cases recovered showed any indication of being pried from jammed weapons.[7] This did not account for cases removed by a cleaning rod or other objects nor for jammed rifles cleared away from the immediate battle area and outside the very limited archaeological survey area. Every Custer battalion weapon became Indian property. Captain Thomas French, M Company Commander was kept busy on the Reno defensive position line using the cleaning rod from his infantry rifle to clear the jammed carbines passed to him from the cavalryman on the line. The cartridge was subsequently redesigned with a brass case, since that material did not expand as much as copper.[citation needed] This was shown to be a major improvement, and brass became the primary material used in United States military cartridges from then to the present. After the Little Big Horn disaster, troops were required to perform target practice twice a week.[citation needed]
The black powder Model 1873 continued to be the main service rifle of the U.S. military until it was gradually replaced by the Springfield Model 1892 bolt action rifle, a derivative of the Norwegian Krag–Jørgensen action. Replacement began in 1892, and despite its obsolescence, the Model 1873 was still used by secondary units during the Spanish–American War in Cuba and the Philippines, where it was at a major disadvantage against Spanish forces armed with the 7 mm Spanish Model 1893 Mauser bolt-action rifle.
Pictorial chronology
Historical Depictions of 1873 Springfield Rifle Reenactment firing a Springfield Model 1873 breech-loading rifle at Fort Mackinac in 2008 Custer Era Springfield .45 caliber trapdoor carbine, ca. 1875 [8] |
See also
References
- ^ "U.S. Springfield Trapdoor Production". Springfield Armory National Historic Site ~ National Park Service. Springfield, Massachusetts: U.S. Department of the Interior.
- ^ a b c d e Springfield Armory (U.S.) (1887). Description and Rules for the Management of the Springfield Rifle, Carbine, and Army Revolvers, Caliber 45. U.S. Government Printing Office.
- ^ BOARD of OFFICERS (1873). Ordnance memoranda, Issue 15. United States. Army. Ordnance Dept. pp. 99–106.
- ^ a b Springfield Armory (U.S.) (1874). Description and Rules for the Management of the Springfield Rifle, Carbine, and Army Revolvers, Caliber 45. U.S. Government Printing Office.
- ^ Benton, James Gilchrist, 1820-1881, Henry Metcalfe, and United States. Ordinance Dept. Description And Rules for the Management of the Springfield Rifle, Carbine, And Army Revolvers: Calibre .45. Springfield, Mass: National armory, 1874. https://catalog.hathitrust.org/Record/008909513
- ^ Wingate, George Wood (1878). "Manual for Rifle Practice: Including Suggestions for Practice at Long Range and for the Formation and Management of Rifle Associations".
- ^ Fox, Richard A., Archaeology, History and Custer's Last Battle, 1993, University of Oklahoma Press, ISBN 0-8061-2998-0, pp. 241–242
- ^ "Guns on Horseback: Trading for War". Return of the Horse Nation. Smithsonian National Museum of the American Indian.
External links
Media related to Springfield Model 1873 at Wikimedia Commons
- "Springfield Model 1873 Rifle". General History ~ Vehicles, Weapons, and Equipment. Fort Belvoir, Virginia: Army Historical Foundation.
- "The Trap Door Rifle". National Park Service ~ Springfield Armory National Historic Site. Springfield, Massachusetts: U.S. Department of the Interior.
- "U.S. Springfield Model 1873 1879 Trapdoor Carbine". NRAMuseum.org. NRA National Firearms Museum.