Search results

10BASE2 (also known as cheapernet, thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors...

thick coaxial cable as a shared medium. This was largely superseded by 10BASE2, which used a thinner and more flexible cable that was both cheaper and...

one Type C Mini-Centronics 36-pin parallel port. 600n – 10/100BASE-TX/10BASE2/LocalTalk (J3110A, J3111A, J3112A, J3113A) (Discontinued) 610n – Ethernet/Fast...

Attachment Unit Interface (AUI) connector to allow connection to legacy 10BASE2 or 10BASE5 network segments. Hubs are now largely obsolete, having been...

120 ohm resistor. Dummy loads are commonly used in HF to EHF circuits. 10BASE2 networks absolutely must have proper termination with a 50 ohm BNC terminator...

detection are media dependent. On a shared, electrical bus such as 10BASE5 or 10BASE2, collisions can be detected by comparing transmitted data with received...

Ethernet systems usually were 10BASE2, also known as thinnet. Apple's system is called FriendlyNet. A FriendlyNet 10BASE2 system does not use BNC T-connectors...

early computer networks, including ARCnet, the IBM PC Network, and the 10BASE2 variant of Ethernet. The BNC connector is used for signal connections such...

versions RG-58A/U or RG-58C/U was once widely used in "thin" Ethernet (10BASE2), for which it provides a maximum segment length of 185 meters. However...

400 MB, 660 MB, 1.4 GB or 2.8 GB SCSI drive Network interface: 10BASE-T and 10BASE2 Ethernet Expansion: four NeXTbus slots (mainboard uses one slot) Size (H...

tied together with 4 repeaters, with up to 3 mixing segments (10BASE5, 10BASE2, or 10BASE-FP). Link segments can be 10BASE-T, 10BASE-FL or 10BASE-FB....

superseded by much cheaper and more convenient alternatives: first by 10BASE2 based on a thinner coaxial cable (1985), and then, once Ethernet over twisted...

Attachment Units (MAUs) in IEEE 802.3 documents and were widely used in 10BASE2 and 10BASE5 Ethernet networks. Fiber-optic gigabit, 10 Gigabit Ethernet...

This was the layout used in the original Ethernet, called 10BASE5 and 10BASE2. This is still a common topology on the data link layer, although modern...

bus: ISA 16-bit Connections for networking: 10BASE-T (8P8C), AUI (DA-15), 10BASE2 (BNC) Some of the possible ISA I/O bases are 0x280, 0x300, 0x310, 0x320...

without inducing unwanted currents in them. Early Ethernet, 10BASE5 and 10BASE2, used baseband signaling over coaxial cables. The most common use for coaxial...

electronic test equipment. Tee connectors were used to attach end stations to 10BASE2 Ethernet networks. Wikimedia Commons has media related to Tee connectors...

communication mechanism derived from Ethernet. The basic mode is based on 10BASE2, but higher-data-rate encodings for application such as video streaming...

RS-449, RS-485 Etherloop Ethernet physical layer Including 10BASE-T, 10BASE2, 10BASE5, 100BASE-TX, 100BASE-FX, 1000BASE-T, 1000BASE-SX and other varieties...

Etherpocket-SP parallel port Ethernet adapter (c. 1990). Supports both coaxial (10BASE2) and twisted pair (10BASE-T) cables. Power is drawn from a PS/2 port passthrough...